65637bd9



3.2.2.7. The piston assembled with a rod

Removal

PERFORMANCE ORDER
1. Remove a head of cylinders and the oil pallet.
2. If in the top part of cylinders the fillet was formed, then it should be removed development or a shaber, without having damaged at the same time a cylinder wall. Formation of a fillet indicates the increased wear of the cylinder.
3. On a rod and on a cover of a rod number of the cylinder to which this rod belongs has to be stamped. The N1 cylinder is from a cover of a chain of the gas-distributing mechanism. If numbers are not visible, then put tags with paint or a nakernita. To put tags on a pro-polished side surface of a rod and a cover.
4. Turn the crankshaft and install pistons of the 1st and 4th cylinder in the provision of NMT.
5. Turn off nuts of a conrod cover of a rod of the 1st cylinder. Uncover and get the lower connecting rod. If the insert is established again, then paste it an adhesive tape to uncovered.
6. Not to injure conrod necks of the crankshaft stick with a tape of a carving of bolts of a conrod cover.
7. The handle of the hammer push the piston in the cylinder and get the piston through the top part of the block of cylinders. Remove the top insert of the conrod bearing and paste it an adhesive tape to the removed rod.
8. Put a cover on a rod and fix by nuts to keep a former assembly order of details.
9. Having repeated the specified operations, remove a rod with the piston of the 4th cylinder.
10. Turn the crankshaft on 180 ° and install pistons of the 2nd and 3rd cylinder in NMT. Get from these cylinders rods with pistons.