| 1. Remove the right half shaft. |
| 2. Remove the internal CV JOINT, the bearing and the case of the bearing. |
| 3. Clamp a half shaft in a vice and press a mud-reflector blows of the hammer to a mandrel. |
| 4. Hook and get a bearing cover from outside which is turned inside. |
| 5. Get a lock ring of the bearing. |
| 6. Press the bearing assembled with the case from a half shaft. If the bearing changes, then it can be beaten out carefully blows of the hammer to a mandrel. |
| 7. Get a lock ring of the bearing from the outer side. |
| 8. Get a bearing cover. |
| 9. Vypressuyte the bearing from the case blows to a mandrel which rests against an external holder. |
| 10. Before assembly put lubricant in the bearing. |
| 11. Press the bearing in the case so that it was possible to establish a cover and a lock ring. |
| 12. Establish an emphasis under an internal holder and press in the bearing a half shaft blows to an end face through a wooden pro-rate so that it was possible to establish an internal lock ring. |
| 13. Carefully to a napressuyta mud-reflectors. |
| 14. Install the CV JOINT. |
| 15. Establish a half shaft. |
