| 1. Remove the case of a butterfly valve, being guided by the instructions provided in subsection 6.3.1.11. |
| 2. Merge cooling liquid from the cooling system, being guided by the instructions provided in subsection 2.4.5. |
| 3. Remember or mark the provision of installation of all vacuum hoses and hoses of the cooling system of an inlet collector. |
| 4. Disconnect them from an inlet collector and if it is necessary, from the corresponding vacuum valves. |
| 5. Not to mix hoses at installation, mark each of hoses at removal. |
| 6. On models with the catalytic converter turn off a nut of connection and disconnect the tube of recirculation of exhaust gases connecting inlet and final collectors from the valve on the left side of an inlet collector. |
| 7. Disconnect the connection socket from the sensor of temperature of cooling liquid on the right side of a collector. |
| 8. If it is necessary, turn off fixing bolts and disconnect a wire (masses (from an inlet collector. |
| 9. Turn off fixing bolts and remove a fixing arm behind an inlet collector. |
| 10. Check that all vacuum / ventilating hoses were disconnected from an inlet collector. |
|
11. Upside-down turn off and remove fixing nuts and bolts. |
| 12. Remove an inlet collector from a head of the block of cylinders and get it from a motive compartment, then remove laying of an inlet collector and you will throw out it. |
