65637bd9



9.2.2. Cable of management of transmission


Cable of management of transmission
1. Selector
2. Fastening of a cable to a floor
3. Floor
4. Cable
 5. Arm
6. Arm
7. Cable cover nut
8. Transmission lever

Adjustment of a cable

 1. Lever

2. Cable

3. Nut

4. The blocking starter switch

The arrow specified the direction of effort at adjustment.

Adjustment

PERFORMANCE ORDER
1. Transfer the selector to situation P.
2. Lift a forward part of the car and establish on supports.
3. Make sure that the transmission lever is in situation P too.
4. Turn off a nut of fastening of a cable to the lever.
5. Pull a dynamometer for a cable tip eye with a force of 0,7 kgfs.
6. Remove a dynamometer and displace a cable back on 1,0 mm.
7. Holding a cable cover, tighten a lock-nut.
8. Check freedom of movement of the selector.
9. If when moving the selector the cable is bent, then repeat adjustment.
10. Grease the rubbing surfaces of a cable and the lever and lower the car.

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Transfer the selector to situation P.
3. Remove the central section of the forward panel.
4. Turn off a nut, get a bracket of a cover of a cable and disconnect a cable from the selector.
5. Turn off a bolt and remove an arm, extend a cable.
6. Turn off a nut on the lever, get a bracket from an arm and remove a cable. Keep in mind that position of the lever on transmission at installation of a cable should not change (designate position of the lever before removal of a cable).
7. Check existence on a cable of wear tracks and damages.
8. Check freedom of movement of a cable in a cover. Keep in mind that at installation into place the cable can jam, despite the seeming ease of its movement in completely straightened state.
9. At strong damages replace a cable.

Installation

PERFORMANCE ORDER
1. Pass a cable through a floor and tighten fastening bolts to a floor.
2. Attach a cable to the selector and insert a cable cover into an arm.
3. Tighten a nut and insert a bracket.
4. Transfer the selector to situation P, be convinced that the transmission lever is in situation P too.
5. Put on a cable the transmission lever.
6. Fix a cable cover by brackets.
7. Adjust a cable.
8. Establish the central section of the forward panel, lower the car.