9.2.3. Selector

Selector details

1. A slip with the indication of position of the selector

2. Button

3. Spring

4. Handle

5. Socket

6. Control lamp

7. Cable cover bracket

8. Cable

9. Cover

10. Bracket

11. Selector mechanism assembled


1. Lift a forward part of the car and establish on supports.
2. Transfer the selector to situation P.
3. Remove the central section of the forward panel.
4. Turn off a nut, get a bracket of a cover of a cable and disconnect a cable from the selector.
5. Disconnect sockets from the switch of an overload and from a control lamp.
6. Unscrew screws wring out the button and remove the selector handle.
7. If necessary it is possible to remove the button and a spring of the switch.
8. Turn off nuts (access is provided from below and from within salon) and remove the selector mechanism.
9. The mechanism of the selector is the non-demountable unit and to repair will not lie down.


1. Install the mechanism of the selector and tighten nuts.
2. Install a spring and the button in the selector handle.
3. Correct conducting and dress the handle.
4. Tighten screws and check fixing of the selector.
5. Attach sockets.
6. Attach a cable and fix a cover on an arm, tighten a nut and insert a bracket.
7. Adjust a cable of the selector and establish the central section of the forward panel.