1.4.2. Control for the station

1. For the choice mono - or stereoreception press the L.M/U button. On the display symbols of L.MW or UKW will appear.
2. Be adjusted on the necessary station by means of one of the ways offered below. On the display value of frequency of control will appear.
Control in the program mode
3. Press the button of the choice of the station which was in advance brought in memory. The receiver will automatically be adjusted on this station, and on the display number of the button will be displayed (see subsection 1.4.3).
Mode of continuous search
4. In this mode there is a search of the station. After reception of the station control automatically stops. Press at the same time on both parties the TUNE buttons and wait for a continuous sound signal. The receiver will begin to carry out automatically search of the nearest station with higher or lower frequency of broadcasting. After consistent reception control stops. By the subsequent pressing of the button search will continue before consistent reception of the following station.
5. If because of too weak signal it is not possible to be adjusted after single scanning of all range of frequencies, then search will continue, but at hypersensibility, and on the display the symbol DX will appear.
Manual control
6. Press at the same time on both parties the TUNE buttons for a while, not exceeding 0,5 pages. By each pressing of the button there is a jump to the frequency at which broadcasting is possible.