9.1.4. Sensor of neutral situation

Sensor arrangement

The sensor (is established only on cars with converter) is screwed in a check point case bottom on the right side.

Check, removal and installation

1. Disconnect the socket in the top part of a case and check a chain between sensor conclusions.
2. Contacts of the sensor have to be closed only at neutral position of the lever.
3. Otherwise check conducting.
4. If conducting is correct, then replace the sensor.
5. To remove the sensor lift a back part of the car and establish on supports, merge oil from the check point.
6. Disconnect the sensor socket from a plait.
7. Turn out the sensor.
8. Clear a carving of a case and grease a carving of the new sensor with sealant.
9. Screw the sensor.
10. Tighten the sensor and attach the socket.
11. Lower the car, fill in oil in the check point.