| 1. Be adjusted on the necessary station by means of one of the ways offered below. On the display value of frequency of control will appear. |
| Control in the program mode |
| 2. It is used for control for in advance programmed station (see subsection 1.5.3). Press several times the LMU button until on the display there is no chosen information. |
| 3. Press the button with number which was in advance appropriated to the necessary station. There is a control for the necessary station, and on the display number of the button of the necessary station will appear. |
| Mode of continuous search |
4. In this mode there is an automatic search of the station. After reception of the station control automatically stops.
Press at the same time on both parties the TUNE SEEK buttons and wait for a continuous sound signal. The receiver will begin to carry out automatically search of the nearest station with higher or lower frequency of broadcasting. After consistent reception control stops. By each subsequent pressing of the button search will continue before consistent reception of the following station.
If because of too weak signal it is not possible to be adjusted after single scanning in all range of frequencies, then search will continue, but at hypersensibility, and on the display the symbol DX will appear. |
| Manual control |
| 5. Press at the same time on both parties the TUNE SEEK buttons for a while, not exceeding 0,5 pages. By each pressing of the button there is a jump to the frequency at which broadcasting is possible. |
