6.3.2.12.6. Electromagnetic valve of bystry operation of the engine
Prevention
The electromagnetic valve of bystry operation of the engine in the mode of idling is not on sale separately. If it is faulty, it is necessary to replace all block of adjustment of air supply during the operation of the engine in the idling mode. This block fastens to an inlet collector and turns on the additional valve of air supply, the electromagnetic valve of increase in speed of operation of the engine in the mode of idling and the adjusting screw of speed of idling.
The electromagnetic valve of bystry operation of the engine in the mode of idling is installed on the right side of an inlet collector.
Before its removal, disconnect a wire of the negative plug of the accumulator.
Removal and installation
| PERFORMANCE ORDER |
| 1. Walk along wires from the electromagnetic valve to its socket of connection and disconnect the connection socket. |
| 2. Unscrew the electromagnetic valve from an inlet collector, remove a plunger, a spring and a sealing washer. |
| 3. Installation is carried out upside-down removals. At installation use a new sealing washer. Check that the plunger and a spring were correctly established. |
|
