6.3.2.12.7. Air supply adjustment block (idling mode)
The block of adjustment of air supply during the operation of the engine in the mode of idling is installed on the right side of an inlet collector.
Before its removal, disconnect a wire of the negative plug of the accumulator.
Removal and installation
| PERFORMANCE ORDER |
| 1. Disconnect connection sockets from the additional valve of adjustment of air supply and the electromagnetic valve of bystry operation of the engine in the idling mode, and get wires from fixing clips. |
| 2. Turn off fixing bolts and remove the block from an inlet collector. Remove laying and you will throw out it; at installation it is necessary to use new. |
| 3. At installation check that the adjoining surfaces of the block and an inlet collector were pure and dry, then, establish new laying. Establish an air supply adjustment nut, and reliably tighten fixing bolts. Connect sockets of connection and a wire of the negative plug of the accumulator. |
|
