65637bd9

11:12. Vacuum amplifier of brakes

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On carburetor engines the amplifier it is possible to remove without removing the soaking-up collector or the main cylinder.
3. On injector engines for access to the amplifier it is necessary to remove the soaking-up collector.
4. On carburetor engines remove the air filter (cm. subsection 6.1.2).
5. Disconnect wires from the sensor of pressure of the hydraulic booster, remove an arm of a hose of the hydraulic booster.
6. Remove the main cylinder from the vacuum amplifier.
7. Disconnect a hose from the vacuum amplifier.
8. Disconnect a pusher from a pedal and turn off four nuts of fastening of an arm to the amplifier.
9. Remove the amplifier from a motor compartment.

Prevention

Do not damage a carving of hairpins of the amplifier of brakes.


Installation

PERFORMANCE ORDER
1. The amplifier is installed upside-down.
2. Before installation check a pusher vystupaniye over the surface of the case of the amplifier.
3. On cars without ABS system adjust the provision of a pusher of the main cylinder, having exposed the size A.
4. The collector and the main cylinder are established in compliance with subsection 6.2.14 and subsection 11.10.
5. Upon termination of adjust a brake pedal.