| 1. Lift a forward part of the car and establish on supports. |
| 2. Remove forward wheels. |
| 3. Pull a support on yourself that the piston entered the cylinder, watching liquid level in a tank. |
|
4. If necessary press the piston by means of a clamp. |
|
5. Turn away fingers of a support (glaze). |
|
6. Remove a support from a disk. |
| 7. Keep in mind that the external block can remain on an arm. |
| 8. After removal of a support not to press a pedal of a brake. |
|
9. Fix a support so that it did not hang on a hose. |
|
10. Remove adjusting laying. |
|
11. Remove blocks. |
|
12. Remove clamps of blocks. |
| 13. Check thickness of frictional slips. |
| 14. If thickness at least of one slip is less than norm, or blocks are strongly polluted, then replace all blocks in a set with one axis. |
| 15. Find and remove the cause of pollution. |
| 16. It is forbidden to rearrange blocks for the purpose of wear compensation. |
| 17. If a condition of blocks satisfactory, then clear them, having removed the eaten dirt and large particles. |
| 18. Clear surfaces of a prileganiye of blocks in a support and an arm. |
| 19. Before assembly check freedom of movement of fingers in an arm and a support, and also integrity of rubber covers. |
| 20. Check a condition of sealants of the piston, existence of corrosion on the piston and dribble traces. |
| 21. If blocks change, then the piston should be displaced to provide the place for blocks. |
| 22. At the shift of the piston you watch liquid level, excess of liquid should be removed with a rubber pear or the syringe. |
| 23. Slightly grease plates of blocks, laying and spring brackets with special antinoise lubricant. |
| 24. Establish brackets, blocks and laying in a support arm. The external block is established in an arm, and internal – in a support. |
| 25. Make sure that the clamp of an internal block came into gearing with the piston. |
| 26. Establish a support, grease support fingers with the fixing structure and turn. |
| 27. Tighten fingers with the set moment. |
| 28. Check freedom of movement of a support on fingers. |
| 29. Repeat the described actions for a brake of other wheel. |
| 30. Press several times a brake pedal. |
| 31. Establish wheels, lower the car. |
| 32. Check liquid level. |
| 33. Before departure check work of brakes. |
