6.1.11. Sensors and valves of the carburetor
Removal and installation
PRESSURE PRESSURE SENSOR
| PERFORMANCE ORDER |
| 1. The sensor is mounted on the left cap of a suspension bracket. |
| 2. Disconnect the battery from weight. |
|
3. Unscrew screws raise the sensor and disconnect a hose (2) and the socket (1), remove the sensor. |
| 4. Installation is carried out upside-down. |
|
TRANSISTOR MODULE
See subsection 7.7.6.
VALVE OF CORRECTION OF COMPOSITION OF MIX
Cm. subsection 6.1.10.2.
SOLENOIDAL VALVES
Cm. subsection 6.1.10.2, subitem 18-26.
For expansion of a workplace remove the air filter.
SWITCH OF THE BUTTERFLY VALVE
Switch arrangement
|
|
The switch of a throttle zasloka is mounted on the right side of the carburetor. |
| PERFORMANCE ORDER |
| 1. Unscrew two screws. |
| 2. Disconnect wires and remove the switch. |
| 3. At installation adjust the switch. |
| 4. For adjustment warm up and stop the engine, disconnect the socket with switch wires. |
|
5. Connect crossing points conclusions of the gate-type valve and connect an ohmmeter (shooters specified conclusions for connection of an ohmmeter). |
| 6. Start the engine, bring turns to 2000 rpm and slowly reduce, watching an ohmmeter which has to show the closed chain, and on 1200 rpm – disconnection (the switch works). |
| 7. If necessary adjust the switch a uvula podgibaniye. |
| 8. Stop the engine and attach the socket. |
|
SENSOR OF TEMPERATURE OF COOLING LIQUID
Cm. subsection 4.6.3.
CONTROL UNIT
The block is mounted or under one of front seats, or under the central section of the forward panel.
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Remove a seat or the central section. |
| 3. Unscrew screws and remove the block, disconnect conducting. |
| 4. At installation be convinced of correctness of all connections. |
|
SENSOR OF THE ANGLE OF ROTATION OF THE CRANKSHAFT
The sensor enters a design of the distributor of ignition and separately is not removed.
At an exit from the sensor of a system all distributor in collecting changes (see
subsection 7.7.4).
COUPLING SWITCHING OFF SENSOR
It is mounted on an arm of the block of pedals.
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight, remove the lower panel. |
| 2. Disconnect wires, turn off a nut and remove the switch. |
| 3. At installation check adjustment of a pedal of coupling and adjust the sensor. |
| 4. For adjustment connect an ohmmeter to sensor conclusions and adjust situation so that at the released pedal there was a gap, and at slightly pressed – the closed chain. |
| 5. Tighten a nut. |
|
SENSOR OF NEUTRAL PROVISION OF TRANSMISSION
Cm.
subsection 9.1.4.
THE SWITCH OF CORRECTION OF IDLING DURING THE OPERATION OF THE HYDRAULIC BOOSTER
The switch is built in in a contour of the hydraulic booster, in the right back part of a motor compartment.
| PERFORMANCE ORDER |
| 1. Put wheels in driving position on a straight line and disconnect the battery from weight. |
| 2. Disconnect the socket from the switch. |
| 3. Unscrew the switch and muffle an opening in a tube, get a sealant. |
| 4. At installation replace a sealant. |
|
CAR SPEED SENSOR
The sensor is mounted in a speedometer.
