65637bd9



12.2. Bearings of naves of forward wheels

Replacement

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Remove a wheel.
3. Remove a disk and a support.
4. Remove the speed sensor (on cars with ABS system).
5. Turn off fastenings of an arm of conducting and take the sensor aside.
6. Disconnect a half shaft from only from a nave, take aside and fix (see subsection 10.2).
7. Turn off two nuts of fastening of a rack to a rotary fist (are specified by shooters), get bolts and disconnect a rack.
8. Rasshplintuyte also turn off nuts, a vypressuyta a spherical support and a tip of steering draft from fist eyes.
9. Vypressuyte a nave from the bearing. On a nave there has to be one of internal holders of the bearing.
10. Press a bearing holder from a nave.
11. Get an external epiploon.
12. Get an internal epiploon.
13. Get from an opening in a fist under the bearing a lock ring.
14. If landing of the remained holder weakened, then get a holder.
15. Vypressuyte the bearing from a fist a mandrel of suitable diameter which rests only against an external part of the bearing.
16. At a vypressovka it is necessary to rest a back part of a fist.
17. It is possible to Vypressovat the bearing also blows to the inserted internal holder through a tubular mandrel.

Installation

PERFORMANCE ORDER
1. Before installation of the new bearing carefully clear the internal surface of a fist.
2. Press an external holder of the bearing, resting a mandrel only against an external edge. It is forbidden to grease an external part of a holder for simplification of a press fitting.
3. Insert into a flute in a fist opening a lock ring.
4. Put lubricant in a cavity of an epiploon and carefully press an epiploon from the outer side of a rotary fist.
5. Establish a prop of an external part of a fist.
6. Put lubricant in an epiploon and press an epiploon from the inside of a fist.
7. Having reliably rested an internal holder of the bearing, carefully press a nave in a fist.
8. Check freedom of rotation of a nave.
9. Attach a half shaft and tighten a nut with the set moment.
10. Dress a disk and a support of a brake.
11. Attach a spherical support of the lower lever, wrap a new nut and tighten with the set moment.
12. Zashplintuyte nut new forelock.
13. Attach a rack, having replaced bolts and nuts.
14. Tighten bolts and nuts with the set moment.
15. Attach steering draft, having replaced a nut and the forelock.
16. Establish a wheel and lower the car.