12.7. Bearings of back wheels

Bearings change only assembled with a nave.


1. For removal of a nave lift a back part of the car and establish on supports.
2. Remove a wheel.
3. On cars with disk back brakes remove a disk and a support, without disconnecting a hose.
4. On cars with back drum brakes remove a drum.
5. Take off a cap of a nave and a rasshplintuyta an axis nut.
6. Release a nave nut.
7. Turn off a nut, remove a washer and a nave.
8. Clear an axis and dress a new nave with the bearing.
9. Put on a washer and screw a nut (a washer and a nut replace).
10. On cars with drum brakes a drum.
11. On cars with disk brakes establish a disk and a support.
12. Tighten a nut with the set moment.
13. Check freedom of rotation of a nave, a zashplintuyta a nut the new forelock and press a cap.
14. Establish a wheel and lower the car.