65637bd9



11.4.3. Blocks of back drum brakes

Replacement

PERFORMANCE ORDER
1. Remove drums.
2. Clear a board of a brake and drums.
3. Pay attention to an arrangement of back and forward blocks, springs and the regulator of a gap between blocks and drums.
4. Remove clamping springs of blocks for what press a cap and turn on 90 °.
5. Remove springs, caps and get pins from the brake board back.
6. Carefully give on yourself and remove blocks assembled with the regulator and a cable of the emergency brake.
7. Disconnect the top and lower springs of blocks.
8. If necessary tie with a wire the cylinder that there were no pistons if on the cylinder there are traces of dribbles, then replace or repair the cylinder.
9. Disconnect the regulator and a spring from a forward block.
10. Disconnect the regulator and a spring from a back block.
11. Remove the regulator lever from a forward block.
12. Disconnect a cable of the emergency brake from the lever.