13:10. Doors

Removal and installation

1. Disconnect the battery from weight.
2. Remove the internal panel of a door (see subsection 13.11).
3. Disconnect all sockets, designate the route of conducting and get from brackets.
4. Carefully extend conducting from door openings, having got a sealant.
5. Beat out an axis of the limiter of opening of a door.
6. Designate the provision of loops on a door.
7. Supporting a door, turn off bolts of loops and remove a door.
8. Check a condition of loops, if necessary replace, having turned off bolts on a body.
9. Coupling guard.
10. The lower bolts of fastening of a case of coupling to the block of cylinders.
11. The door is established upside-down on the put tags. Replace a limiter axis. If necessary adjust a door.


1. Carefully close a door, check gaps between the next panels.
2. The door is regulated by movement in openings of loops of a door and a body at the released bolts. After adjustment tighten bolts.
3. Check adjustment of the door lock, if necessary adjust movement of a clamp on a body rack at the released bolts which after adjustment tighten.