65637bd9

13:24. Panels of facing of salon

Internal facing panels fasten metal or plastic latches or clamps which are recommended to be got a bifurcate stripper.

In some places for removal of this panel it is required to remove the next panels.

Removal and installation

PERFORMANCE ORDER
The facing panel in a niche of legs of the driver
1. Hook and get a slip, unscrew screws.
2. Turn and get a back clamp, remove the panel.
3. Install the panel upside-down.
Overlays of powder
4. Disconnect an aperture sealant, hook a slip and release latches.
5. At installation press a slip before click.
Overlay of a rack of a body
6. Disconnect a door sealant, hook and remove a slip.
7. At assembly accurately insert a door sealant.
Internal panel of a door
8. See subsection 13.11.
Back shelf (sedan)
9. Remove a back armrest.
10. Disconnect two forward plastic latches of a tray of the shelf.
11. Hook behind and remove a shelf tray.
12. If necessary it is possible to remove the shelf assembled for what turn off the lower bolt of a seat belt and pass a belt via the shelf hatch.
13. Establish the shelf upside-down.
Internal facing of a luggage carrier (sedan)
14. For removal of the back panel remove a sealant and give the panel up, having disconnected from brackets.
15. The flooring of a luggage carrier fastens plastic clamps. Remove arms of fixing tapes and a plafond then get rugs.
16. Assembly is carried out upside-down.
Internal facing of a luggage carrier (compartment and hatchback)
17. Get plastic caps and unscrew 4 screws of fastening of the back panel.
18. The flooring of a luggage carrier is removed as follows.
19. Lift a back part of a flooring.
20. Hook and disconnect latches of a back part of a flooring from a body.
21. Assembly is carried out upside-down.
Internal panel of a trunk lid (sedan)
22. Hook and disconnect plastic latches, get the panel from brackets in a back part of a cover and remove.
23. Assembly is carried out upside-down.
Internal facing of a cargo compartment (hatchback)
24. Hook and disconnect plastic latches, turn out screws. Carefully give the facing panel a bifurcate stripper, having got the latches hidden under a back part of the panel (a photo at the left) and remove the facing panel (a photo on the right).