| Glass |
| 1. Remove the panel and the screen. |
| 2. Install the window regulator handle (or attach the switch socket, connect the battery to weight). |
| 3. Lower glass so that the bolt of the holder of glass appeared in a door framework opening. |
|
4. Supporting glass, turn off bolts of fastening of glass to the holder (are specified by shooters). In cars with a body of a compartment there is an additional bolt of fastening of glass to a roller of a forward guide. |
| 5. Get glass through an aperture. |
| 6. Glass is established upside-down. At installation you watch that the sealant did not lag behind. Before installation of the panel check work of a window regulator. |
| Window regulator (hatchback and sedan) |
| 1. Disconnect glass from a window regulator (see above). |
| 2. Lift glass and fix by a tape or wedges, or get. |
| 3. Disconnect electric drive sockets (if it is provided). |
|
4. Turn off bolts of fastening of the manual drive of a window regulator (or the electric drive) (are specified by shooters). |
|
|
| 5. Turn off top (a photo at the left) and lower (a photo on the right) bolts of the regulator of a window regulator and get the regulator through a window opening. The electric drive with cables gets together with the regulator. Previously designate an arrangement of the disconnected details. |
| 6. The window regulator assembled with the regulator and the drive is established upside-down. Before installation of the panel check work of a window regulator. |
| Compartment |
| 1. Disconnect glass from a window regulator. |
| 2. Disconnect electric drive sockets. |
| 3. Turn off window regulator electric drive bolts. |
| 4. Turn off bolts of both guides and remove a window regulator assembled. Previously designate an arrangement of the disconnected details. |
| 5. The window regulator is established upside-down. Before installation of the panel check work of a window regulator. |
| Corner of a window of a back door – the 5th dverny hatchback |
| 1. Remove lifting section of glass. |
| 2. Turn off bolts and remove a back guide, supporting a corner. |
| 3. Carefully get a corner with a sealant. |
| 4. Remove a sealant from a corner. |
| 5. The corner is established upside-down. |
