2.3.7. Replacement of brake fluid

1. The procedure is similar to removal of air from a hydraulic actuator of brakes (see subsection 11.2). Before replacement of liquid it is necessary to suck away the fulfilled liquid from a nutritious tank a rubber pear or the syringe then to fill in fresh liquid. During removal of air from a contour of the brake highway, it is necessary to extort the fulfilled liquid.
2. Unscrew the first union for pumping of brakes (see subsection 11.2). Slowly press a brake pedal to remove the liquid remains from a nutritious tank.
3. Add fresh liquid to mark MOVE and continue to press a brake pedal so far fresh liquid will not begin to follow from the union. Wrap the union and add in a tank fresh liquid to mark MOVE.
4. Repeat this operation, serially turning off the others of the union of pumping and pressing a pedal up to one emergence fresher than liquid. Always support liquid level in a nutritious tank above the mark MIN, otherwise air because of what duration of pumping of brakes considerably will increase can get to the highway.
5. Upon termination of tighten the union and dress on them protective caps. Carefully wipe the remains of the spilled liquid and check level in a nutritious tank of the main cylinder of brakes.
6. Before a trip check work of brakes.