65637bd9

2.3.1.1. Conditioner compressor belt

Removal

PERFORMANCE ORDER
1. Working under a forward part of the car, unscrew screws and remove a plastic guard under a wing to get access to a crankshaft pulley. For expansion of working space it is possible to remove also in addition an engine mudguard, having unscrewed screws.
2. Turn the crankshaft the face head dressed on a pulley bolt so that it was possible to examine belts (or a belt) on all length. Check existence on belts of cracks, traces of a podgoraniye or mechanical damages. Check also existence on a belt of glossy sites and stratifications. At detection of damages or wear tracks replace a belt.
3. Disconnect the battery from weight.
4. Release a nut of fastening of a natyazhitel of a belt to the engine.
5. Turn off an adjusting bolt, displace a roller of a natyazhitel from a belt, before its full easing and take off a belt from pulleys.

Installation

PERFORMANCE ORDER
1. If the new belt is established, then previously be convinced that its type in accuracy corresponds to type of replaced.
2. Put on a belt on pulleys.
3. Rotating an adjusting bolt, pull a belt.

Adjustment of a tension
PERFORMANCE ORDER
1. Working under a forward part of the car, unscrew screws and remove a plastic guard under a wing to get access to a crankshaft pulley. For expansion of working space it is possible to remove also in addition an engine mudguard, having unscrewed screws.
2. Turn the crankshaft the face head dressed on a pulley bolt so that it was possible to examine belts (or a belt) on all length. Check existence on belts of cracks, traces of a podgoraniye or mechanical damages. Check also existence on a belt of glossy sites and stratifications. At detection of damages or wear tracks replace a belt.
3. The correct tension of a belt allows to prolong the term of its service. Avoid an excessive tension of a belt, otherwise wear of bearings of the generator amplifies.
4. The tension of a belt is checked in deflection size in the middle between two pulleys in the top part of a contour of the belt drive. Under the influence of the set effort the deflection of a belt has to be within norm.
5. For adjustment of a tension release a nut of a roller of a natyazhitel and rotate an adjusting bolt before receiving a normal tension. After adjustment turn the crankshaft on two turns and again check a belt tension.
6. Upon termination of tighten a nut of a roller of a natyazhitel with the set moment and connect the battery to weight.
7. Establish the removed guards, a wheel and lower the car.